MK7 TDI DSG adaptation procedure

Does anyone know the right mk7 DSG adaptation procedure? Please, share a link, thank you

is the procedure for ours MK7 TDIs the same as here?
http://wiki.ross-tech.com/wiki/index.php/6-Speed_Direct_Shift_Gearbox_(DSG/02E)


or do we have a different transmission than 02E?

apparently it is different, you cant even access measuring blocks with VCDS on these cars, have to go through the advanced measuring values instead, and since measuring blocks greyed out adaptation procedure is different, transmission code 0D9

Try looking on 'tex at those GTI bois.

Or have you reached out to Rosstech?

740GLE said:

Try looking on 'tex at those GTI bois.

Or have you reached out to Rosstech?

Click to expand...

it looks like the GTI procedure is different. I have completed the DSG oil change and ran only this adaptation that I found, seems to be working fine, no issues.


http://wiki.ross-tech.com/wiki/index.php/6-Speed_Direct_Shift_Gearbox_(DSG/0D9)




Prerequisites:
Transmission fluid temperature between 30°C - 100°C confirmed using Advanced Measuring Values:
** IDE00102 Control Module temperature
** IDE00024 Transmission fluid temperature

Selector lever in Park

Engine idle speed, do not press accelerator pedal

Parking brake and foot brake applied during the entire procedure. This can be confirmed using Advanced Measuring Values:
* IDE02713 Brake Light Switch
* IDE02714 Brake test switch

0D9 - DQ250 MQB - Basic Settings Procedure:
[Select]
[02- Auto Trans]
[Basic Settings-04]
Select [Basic settings of transmission]
[Show Measuring Data] and select:
* IDE00021 Engine speed
* IDE00322 Status of basic setting
* IDE00024 Transmission fluid temperature
[Go!]

- During the basic setting procedure, there may be some loud gear shifting noises from the transmission, this is normal.

Basic settings may not complete successfully if:
- The fluid temperature gets too hot.
- Brake is released
- Engine RPM is increased

Once complete, there should be an indication of this in the [Status of Basic Settings] Advanced Measuring Value group and Basic Settings should report Finished Correctly..

[Done, Go Back] and Check for fault codes. If you have several Intermittent fault codes stored please [Save] them before clearing so the text can be pasted here with any feedback you happen to have.

kind of resurrecting the old thread, but does anybody else have a clear adaptation procedure for the 0D9 DQ250 transmission ?