stp1971
Active member
I am looking to run a toggle switch versus using the factory headlight switch. I have purchased the VW retrofit kit with the wiring harness. I have a 2012 Passat SE. On the VW retrofit kits harness I assume the red wire runs the power for the lamps. The green/yellow is the trigger wire.
The black and white that plugs into the BCM is my question. What do those wires do? If I do not plug that into the BCM should I connect the two black/white leads together and will that basically eliminate the headlights high beam fog off function?
I have a single pole single throw toggle. Power in. Power out. Ground.
Is there someone who knows if the white/blacks could be used with the toggle. Tape them off. Or just connect them together?
Wiring diagram in simple man terms would be awesome!! I have a nice clean toggle with red LED light that I plan on using that I think will tie in nicely with the dash.
Once done I'll post pics of the install if someone can help me with the wiring layout.
The black and white that plugs into the BCM is my question. What do those wires do? If I do not plug that into the BCM should I connect the two black/white leads together and will that basically eliminate the headlights high beam fog off function?
I have a single pole single throw toggle. Power in. Power out. Ground.
Is there someone who knows if the white/blacks could be used with the toggle. Tape them off. Or just connect them together?
Wiring diagram in simple man terms would be awesome!! I have a nice clean toggle with red LED light that I plan on using that I think will tie in nicely with the dash.
Once done I'll post pics of the install if someone can help me with the wiring layout.