Car wouldn't start

At this point I have started to pull my hair out. I have 2.0 125kw Seat Leon, which is little bit modified. EGR & DPF delete, chip, turbo, jne.

All started when car stalled on me trying to get going in 3'rd gear(my bad). Turned back on without any problems, but then randomly stalled again. Tried cranking it, but nothing happened. Fast forward, I have tried pretty much everything. Engine doesn't make any weird noises, and cranks normally, but doesn't fire up. Checked if there were any codes with VAG-COM. VAG showed 1 error on Gateway data bus. "CAN Bus cannot be reached", and with some other tool it showed DTC. 01305 - Databus infotainment - No Signal/Communication.
I have checked ECU(No moisture), gone through miles of wiring, checked every fuse, disabled different modules. Diesel comes up, and injectors are fine. Checked both diesel pumps(In tank, and the one next to engine). Car has new fuel in it as well. Maybe bad ECU, bad chip?

I have lost all hope.

have you checked your cecm? all can bus goes through it. sounds like a module has failed and is corrupting the signal. can you get into every module with vag com?

I can access every module, but when i try to run a test on Gateway Can bus, it gives me this error. And when I was using VCDS, and relay 449 on the Module got hot.

If picture doesn’t load, it has error Refused by Control module, state 09. Mes - 7F 22 22
Any idea? Bad module or bad wires?