Runninwild
Veteran Member
Hey I just had a look at the alh pinout sticky. From what I gather these are the wires I need to keep and everything else can be cut/deleted with a tune?
The 6 wires to the obd2 dlc port
the 7 wires for the glow plug relay
T14A connector pins 5 ( fused 30amp), 6 (fused 10amp) and 9 ground. This looks to be the connector for the factory sensors. Can this all be deleted if running external gauges?
T10 Orange pin 5 for the map/iat
T10 Blue keep everything for the pedal
T10 white pin 9 for map/iat
T10 black completely cut out?
T6 brown keep everything but pin 3 for the starter signal?
The only things I didn't notice on the pinout was for the n75 valve. is this needed without vnt or can a tuner delete it? or anything for a crank sensor
I also didn't see a signal wire on the cluster pinout to throw the cel, or if there is a signal wire for a glow plug light?
Can anyone confirm if this is correct or if there is anything else I would need to do? I think im oversimplifying it
The 6 wires to the obd2 dlc port
the 7 wires for the glow plug relay
T14A connector pins 5 ( fused 30amp), 6 (fused 10amp) and 9 ground. This looks to be the connector for the factory sensors. Can this all be deleted if running external gauges?
T10 Orange pin 5 for the map/iat
T10 Blue keep everything for the pedal
T10 white pin 9 for map/iat
T10 black completely cut out?
T6 brown keep everything but pin 3 for the starter signal?
The only things I didn't notice on the pinout was for the n75 valve. is this needed without vnt or can a tuner delete it? or anything for a crank sensor
I also didn't see a signal wire on the cluster pinout to throw the cel, or if there is a signal wire for a glow plug light?
Can anyone confirm if this is correct or if there is anything else I would need to do? I think im oversimplifying it