Gents,
I have a BEW long block which suffered a broken timing belt, and needs to be redone.
Assuming the head is salvageable, if it was sent to Frank, would a BEW head physically fit on a BHW block?
As it is, my head is fine right now save for a slight "my bearings are starting to wear" whine from the cam.
Plan would be to have the BEW head redone, line bored, cam and lifters installed as well as redone injectors, ready to go when the cam finally goes.
Thoughts? I know about the split ports, but most threads seem to indicate they would stay in place but not do anything.
I have a BEW long block which suffered a broken timing belt, and needs to be redone.
Assuming the head is salvageable, if it was sent to Frank, would a BEW head physically fit on a BHW block?
As it is, my head is fine right now save for a slight "my bearings are starting to wear" whine from the cam.
Plan would be to have the BEW head redone, line bored, cam and lifters installed as well as redone injectors, ready to go when the cam finally goes.
Thoughts? I know about the split ports, but most threads seem to indicate they would stay in place but not do anything.