Hello,
I have a Skoda Octavia 2.0 1Z TDI 2005. Fitted with the BKD engine.
Im thinking about a chiptune where the motor will get approx 190 HK/430 NM
The gearbox is the 6 gear (I think the type is called DQ250).
Is this gearbox able to handle the increased torque without any problems ?
And is the engine ?
The engine have had a new turbo 30000 kms ago. and runs fine.
The only thing that annoys me, is that my old AWX 1,9 tdi, startet just by looking at the keys, and this 2.0 PD seem to run on the starter for about a second before it starts. It this normal ?
The torsion value in channel 4, measurement block 4 is 1 KW. As far as i understand, that has something to to with the timing. Would it helt my starting problems, to adkust this value to zero ?
Thanks in advance
Regards
Mikkel
I have a Skoda Octavia 2.0 1Z TDI 2005. Fitted with the BKD engine.
Im thinking about a chiptune where the motor will get approx 190 HK/430 NM
The gearbox is the 6 gear (I think the type is called DQ250).
Is this gearbox able to handle the increased torque without any problems ?
And is the engine ?
The engine have had a new turbo 30000 kms ago. and runs fine.
The only thing that annoys me, is that my old AWX 1,9 tdi, startet just by looking at the keys, and this 2.0 PD seem to run on the starter for about a second before it starts. It this normal ?
The torsion value in channel 4, measurement block 4 is 1 KW. As far as i understand, that has something to to with the timing. Would it helt my starting problems, to adkust this value to zero ?
Thanks in advance
Regards
Mikkel