Alright, I know this is a little backwards but I started the exhaust from the back of the truck. I had these tips left over from a project on my g35 so hey, can't let them go to waste right!
Tacked up and ready for welding.
The exhaust will be 2.5" straight pipe with a couple of large straight through resonator/mufflers that I also had left over from the g35 project.
And here is how far I got before needing to have my trans and engine in place.
Gauges arrived! These are factory match 4th gen dodge gauges but I used them anyway cause they looked nice.
Time to make a custom pillar pod.
Step 1 remove original a-pillar trim to make new part off of.
Step 2 Add raised area for gauge wires to go.
Step 3 Cover with tin foil.
Step 4 Layer on fiberglass.
Step 5 Trim and add cardboard tubes that luckily fit the gauges perfectly.
Step 6 A little bit of filler.