K2edg
Active member
Does anyone have any ideas what could be causing my Trunk problem.
In a nut shell, i have been having epic CCM problems and have very nearly got a fully working passat
but one problem that has popped up is that when i open the car from the drivers door it unlocks the doors and trunk lid ok but when i lock it the trunk lid stays open.
I have done a fair bit of reading up on this and have tested the power/signal (oviously working ok when opening but doesn't apear to be a signal when locking) i also saw that the boot light Microswitch could be an issue but that works fine (light comes on when the boot is open and goes off when closed as it should)
So as the motor does work to unlock it i have ruled out the solanoid, the boot light works so its not the Microswitch so it really only leaves the wiring.... BUT!! i dont know where it goes? and i am under the impresion that to open and lock the ccm just switches the polarity so it turns the motor clockwise to open for example and anticlockwise to lock, but if this is the case then that rules out the wiring too as it works one way???? so should i be looking for a CCM?
Any help or pointers would be handy as i am at the point where i can't see the wood for the tree's
HELP!!!
In a nut shell, i have been having epic CCM problems and have very nearly got a fully working passat
I have done a fair bit of reading up on this and have tested the power/signal (oviously working ok when opening but doesn't apear to be a signal when locking) i also saw that the boot light Microswitch could be an issue but that works fine (light comes on when the boot is open and goes off when closed as it should)
So as the motor does work to unlock it i have ruled out the solanoid, the boot light works so its not the Microswitch so it really only leaves the wiring.... BUT!! i dont know where it goes? and i am under the impresion that to open and lock the ccm just switches the polarity so it turns the motor clockwise to open for example and anticlockwise to lock, but if this is the case then that rules out the wiring too as it works one way???? so should i be looking for a CCM?
Any help or pointers would be handy as i am at the point where i can't see the wood for the tree's