shizzler
Veteran Member
Hi gang,
Just swapped my OE fuel sending unit for an in-tank PD lift pump. Ever since the swap, the fuel level reading never gets to empty. This morning I stalled while trying to push my limits on how much fuel I had left - thankfully I had 5 gals in the trunk. The sender/PD pump unit is installed with the arrow facing towards the back of the car.
Is there a way to electronically adjust the indicated fuel level, i.e. to re-interpret the level-sender resistance? If not I may end up just bending the sender float up so that the sensor arm reads lower....
Thanks
Just swapped my OE fuel sending unit for an in-tank PD lift pump. Ever since the swap, the fuel level reading never gets to empty. This morning I stalled while trying to push my limits on how much fuel I had left - thankfully I had 5 gals in the trunk. The sender/PD pump unit is installed with the arrow facing towards the back of the car.
Is there a way to electronically adjust the indicated fuel level, i.e. to re-interpret the level-sender resistance? If not I may end up just bending the sender float up so that the sensor arm reads lower....
Thanks