miatamike203
Veteran Member
So i sold off my bmw turbo and manifold setup and bought a turbo from a vendor here on TDiclub. The vendor is Xman turbos, what i got for the price i paid is just amazing to say the least.
He built me a custom turbo GT1752V with a 6+6 billet Compressor wheel and it has a GT22V compressor housing on it. It fits just like stock and even looks stock if you dont know what to look for.
Here are some photos of the turbo itself.
Hoping by some time next month ill have this turbo along with a few other mods in.
GT1752V
Stage 1 bosio race 520
11mm IP
2.5" turbo back
Upgraded smic
Custom lower and upper IC pipes
Custom intake pipe
Spec clutch rated for 450tq
Stage 5 Malone tune
EGR delete
3 bar map sensor
Defi Advance ZD gauge
I believe those are the basics, goal is to hit 200hp 350tq. Good thing is i have access to a dyno that doesnt cost me anything to use and i can datalog with my Defi gauge also. So vcds, dyno and defi gauge should help get the most out of the car tuning wise. The defi gauge also has a extra pressure sensor that i dont need so im thinkinh of using it for EMP.
Im on the fence about headstuds and a lift pump though. Thoughts on those would be greatly appreciated along with anything else I might have forgotten.
He built me a custom turbo GT1752V with a 6+6 billet Compressor wheel and it has a GT22V compressor housing on it. It fits just like stock and even looks stock if you dont know what to look for.
Here are some photos of the turbo itself.
Hoping by some time next month ill have this turbo along with a few other mods in.
GT1752V
Stage 1 bosio race 520
11mm IP
2.5" turbo back
Upgraded smic
Custom lower and upper IC pipes
Custom intake pipe
Spec clutch rated for 450tq
Stage 5 Malone tune
EGR delete
3 bar map sensor
Defi Advance ZD gauge
I believe those are the basics, goal is to hit 200hp 350tq. Good thing is i have access to a dyno that doesnt cost me anything to use and i can datalog with my Defi gauge also. So vcds, dyno and defi gauge should help get the most out of the car tuning wise. The defi gauge also has a extra pressure sensor that i dont need so im thinkinh of using it for EMP.
Im on the fence about headstuds and a lift pump though. Thoughts on those would be greatly appreciated along with anything else I might have forgotten.