BEW Running Issues, possibly limp mode?

These are the codes I had,

P0672
P0674
P0673
P0403

First 3 relating to the glow plugs, I know my harness needs to be replaced and the last one was an EGR code so I took it out and cleaned it up and put it all back together. CEL turned off so i took it for a drive and still the same thing, no power... here's some videos

http://www.youtube.com/watch?v=VmPcq1wwkn4
http://www.youtube.com/watch?v=StjsggSnDTA&feature=relmfu

Im underneath the car right now and I cant find any loose IC hoses anywhere, Im going to take off the SMIC and see if its clogged up. Im really hoping its not the actuator

Check your in-tank lift pump. My CEL's never turn off by themselves or did you turn it off?

What am i checking for on the pump? and yeah it turned off on its own

What a fail of a day

Checked all the IC pipes although a little loose at the connections, they shouldnt be a big deal

Had to cut one of the bolts off that hold the SMIC on and burned my hand cause the bolt feel on it haha...

Rusty ass screws holding the MAP sensor on both snapped even after soaking them with wd40


I can thank my dad for this...


forever 4x4 :facepalm:

Tomorrow,
check vac lines
clean map and maf
check intake tube for any cracks
dad's taking the smic to work to remove the screws
buy new map sensor connector (1J0-973-704)
assemble everything and hope for the best

Doggie collar intake fix is on the way from KermaTDI