How to get these clamps off?
- Thread starter Nohlan_4
- Start date
BobnOH
not-a-mechanic
Will these do it?
Recently added to my kit.
Recently added to my kit.
Last edited:
Link doesn’t work?
BobnOH
not-a-mechanic
Try "Cable-operated Hose Clamp Pliers" or just Hose Clamp Pliers.
I have seen those but there isn’t much to grab onto with those clips. There is no tabs?
POWERSTROKE
Top Post Dawg
Were there tabs there at one point?
KyleMillione
Veteran Member
From the picture I think that’s one of the snap in boost hoses. As far as I know you can’t replace just the clamp there.
drucifer
Veteran Member
From what I could see that pipe is an assembly.
If you get the clamp off what then? Either the hose itself is split or the o ring needs replaced or the nubs are worn down and not keeping a good seal. Also the alternative that the hose is fine and your problem is elsewhere.
If you get the clamp off what then? Either the hose itself is split or the o ring needs replaced or the nubs are worn down and not keeping a good seal. Also the alternative that the hose is fine and your problem is elsewhere.
It looks like to me in order to get this pipe off the car then I need to take of that odd clamp. The picture isnt the actual picture it was only to reference the clamp. The pipe i'm talking about is compressor outlet pipe on a BRM.
See above.
runonbeer
Maintenance EnthusiastVendor
Just cut it and replace it with a regular hose clamp.