ALLTQTDI
New member
I would first like to start off by thanking everyone one on the forum for all the info I am able to read about for any questions I have had so far up until now. I just performed an EGR delete/ race pipe install using the DieselGeek kit. Everything went smoothly with the install minus a few busted knuckles . But once I finished the install of the block off plate and the race pipe, there was 2 of what im assuming to be vacuum hoses that was attached to the top of the old EGR valve and another that was connected to the black plastic valve mounted to the side of the EGR. I blocked them off with screws so that they were not just sucking in hot air. Now, I noticed that every time I turn off the engine, it jerks a fair amount. Much more noticeable than before. Is this supposed to happen? Do I need to bypass those vacuum lines? Any help would be greatly appreciated and thanks again.