www.tdiclub.com

Economy - Longevity - Performance
The #1 Source of TDI Information on the Web!
Forums Articles Links Meets
Orders TDI Club Cards TDIFest 2016 Gone, but not forgotten VAG-Com List Unit Conversions TDIClub Chat Thank You




Go Back   TDIClub Forums > TDI Model Specific Discussions Areas > VW MKVI-A6 Golf family including Jetta SportWagen (~ 2010-2014)

VW MKVI-A6 Golf family including Jetta SportWagen (~ 2010-2014) Discussions area for A6/MkVI (2010-2014) Golf and Golf Wagons (Jetta Sportwagon in the USA).

Reply
 
Thread Tools
Old June 9th, 2018, 22:39   #1
surfstar
Veteran Member
 
Join Date: May 2017
Location: SB, CA
Question 2011 Golf No Start - help please!

Got a bit of a project:
https://www.youtube.com/watch?v=BkQn0SVbti4
This car sat for an unknown amount of time (up to a year+ possibly?), then I got it a few months back. Couldn't work on it until recently, and I knew the battery was going out and causing a no crank issue then. Only info I had. I pulled codes (only have OBD11 not VCDS) and got
P2463 - Diesel Particulate Filter - Soot Accumulation static
P2016 - Intake Manifold Runner Position Sensor/Switch Circuit Low static
Then it sat for a few months and the battery fully died.

Finally got time to grab a new battery today to throw it in. I was hoping it could be the fix, as these cars seem picky about proper voltage according to my research.
Car sat long enough with a dead battery that doors wouldn't lock, etc, and codes cleared I believe.
Cranks now, still no start. See video of attempts, if it helps.
Pulled codes: same P2463 and P2016.
Cleared codes, then did only one start attempt and the codes didn't set. Fuel issue?

I've been researching what I can and don't have much experience with TDIs. Anti-Shudder Valve (ASV) - can't find it. On a CJAA I think its integrated into the intake manifold, correct? Can it still cause a no-start? P2016 related?
Fuses seem fine.
Afterwards, I checked the fuel filter and didn't see signs of metal debris (2011 w/ 146k mi, unknown service history). Will priming possibly solve the no start? Didn't crank after cracking open the fuel filter. I need to manually prime without VCDS, unless I can find a way with OBD11.

Apparently a flashing glow plug light doesn't mean that they are bad.

Other avenues to explore?
Any and all help appreciated!

Last edited by surfstar; June 9th, 2018 at 23:14.
surfstar is offline   Reply With Quote
Old June 21st, 2018, 21:00   #2
surfstar
Veteran Member
 
Join Date: May 2017
Location: SB, CA
Default

Bump for any thoughts...
surfstar is offline   Reply With Quote
Old July 11th, 2018, 19:49   #3
surfstar
Veteran Member
 
Join Date: May 2017
Location: SB, CA
Default

Primed the fuel system with OBD11, tried again, cranks - no start still.

Tempted to try starter fluid!

I've read the debates on that, though...
surfstar is offline   Reply With Quote
Old October 1st, 2018, 20:05   #4
surfstar
Veteran Member
 
Join Date: May 2017
Location: SB, CA
Default

So, I couldn't get it to fire on WD40 - but a bit of stater fluid and it did fire.
I disconnected the glow plugs first.

Wouldn't stay running, but it might have been enough to get me a new code:
P0087 - Fuel Rail/System Pressure - Too Low Short circuit to B+
static

now to read up on FP issues... and hope its not the HPFP
surfstar is offline   Reply With Quote
Old October 1st, 2018, 21:16   #5
turbobrick240
Veteran Member
 
turbobrick240's Avatar
 
Join Date: Nov 2014
Location: maine
Default

Sounds like it might be an immobilizer(ecu) issue. I'd leave the ether alone and prime again with the fuel line from the filter disconnected and routed into a container. Maybe one of the electric pumps crapped out.
turbobrick240 is offline   Reply With Quote
Old October 2nd, 2018, 21:39   #6
surfstar
Veteran Member
 
Join Date: May 2017
Location: SB, CA
Default

yeah, looks like HPFP

Pulled the fuel metering valve and found glittery bits all over the mesh. Looks like its time to investigate the cheapest way to limp around the dealer lot with a replacement / fuel cleaning / etc ...
d'oh
surfstar is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
2011 Golf Wagon - Start then stall The_Hamster VW MKVI-A6 Golf family including Jetta SportWagen (~ 2010-2014) 9 November 1st, 2015 07:01
2011 Golf 6spd Start Issue llancaster12 VW MKVI-A6 Golf family including Jetta SportWagen (~ 2010-2014) 2 June 14th, 2015 18:44
2011 Golf No Start Mystery Cogen Man VW MKVI-A6 Golf family including Jetta SportWagen (~ 2010-2014) 4 November 17th, 2013 17:05
TDI golf SW 2011 won't start at all bosa VW MKVI-A6 Golf family including Jetta SportWagen (~ 2010-2014) 2 April 16th, 2013 16:28
My 2011 Golf vs 2011 BMW 530d rental c17chief VW MKVI-A6 Golf family including Jetta SportWagen (~ 2010-2014) 11 December 15th, 2011 10:12


All times are GMT -7. The time now is 08:44.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright - TDIClub Online LTD - 2017
Contact Us | Privacy Statement | Forum Rules | Disclaimer
TDIClub Online Ltd (TDIClub.com) is not affiliated with the VWoA or VWAG and is supported by contributions from viewers like you.
1996 - 2017, All Rights Reserved
Page generated in 0.16360 seconds with 13 queries
[Output: 73.87 Kb. compressed to 64.83 Kb. by saving 9.04 Kb. (12.24%)]