I have a 2001 IMMO2 golf and installed a IMMO3 FIS cluster a few weeks ago. I was doing somw work on the car and decided to run the wire from T15 pin 1 (brown / red) on the CCM to the green connnector pin 22 on the FIS cluster to get the hood open on the FIS.
When I got in there there was already a brown / red wire going from T15 pin 1 brown / red wire, to the green connectors pin 22 also same brown / red wire.
I checked with Vagcom and hood latch micro switch if funtioning properly so it must be connected to the CCM. Checked brown / red wire at the cluster and it has continuity to the T15 pin 1.
Any ideas why I do not get the hood open icon / symbol on my cluster?
I have recoded the CAN to its original code during cluster installation and the enabled the drivers door open symbol and rear hatch open symbol. but I can't get the hood open symbol to come up.
Any help is appreciated.
When I got in there there was already a brown / red wire going from T15 pin 1 brown / red wire, to the green connectors pin 22 also same brown / red wire.
I checked with Vagcom and hood latch micro switch if funtioning properly so it must be connected to the CCM. Checked brown / red wire at the cluster and it has continuity to the T15 pin 1.
Any ideas why I do not get the hood open icon / symbol on my cluster?
I have recoded the CAN to its original code during cluster installation and the enabled the drivers door open symbol and rear hatch open symbol. but I can't get the hood open symbol to come up.
Any help is appreciated.