View Single Post
Old April 18th, 2002, 20:13   #18
SVTWEB
Veteran Member
 
Join Date: Aug 2001
Location: Beyond Comprehension
Default Re: MFA Cluster Conversion Installation Information

Jarrod... Here's all the info I could gather. I didn't find anything on the Outside Temparature, but I did find the MPG adaptation.

Multi-function Indicator (MFI) fuel consumption indicator, adaptation

Notes:

Consumption indicator can only be adapted once between 85% and 115%.

Value must be entered in steps of 5%.

- Connect scan tool VAG 1551, select operating mode 1 "Rapid data transfer", switch on ignition and enter address word 17 "instrument cluster".

- Press -Q- button to confirm input.

- Press button until "Select function"appears in display.

Rapid data transfer HELP

Select function XX

Indicated on display:

- Press buttons -1- and -0- to select "Adaptation" function 10.

Rapid data transfer Q

10 - Adaptation

Indicated on display:

- Press -Q- button to confirm input.

Adaptation

Enter channel number XX

Indicated on display:

- Press buttons -0- and -3- to select adaptation "channel 03".
- Press -Q- button to confirm input.


--------------------------------------------------------------------------------

01-133

Channel 03 Adaptation 100

- 1 3-

Indicated on display:

- Press button to continue.

Note:

Correction of fuel consumption display is only possible via direct input.

Channel 03 Adaptation 100

Enter adaptation value XXXXX

Indicated on display:

- Input desired correction value using scan tool button pad, filling initial positions with "0".

Example:

Desired input value: 90% = button pad entry: 00090

Channel 03 Adaptation 100 Q

Enter adaptation value 00090

Indicated on display:

- Press -Q- button to confirm input.

Channel 03 Adaptation 90 Q

- 1 3-

Indicated on display:

- Press -Q- button to confirm input.

Channel 03 Adaptation 90 Q

Store changed value?

Indicated on display:

- Press -Q- button to confirm input.


--------------------------------------------------------------------------------

01-134

Channel 03 Adaptation 90

Changed value is stored

Indicated on display:

- End consumption indicator adaptation with button.

Rapid data transfer HELP

Select function XX

Indicated on display:

Note:

A false entry switches the tester to "Select function" mode.

Function is unknown or

cannot be carried out at the moment

If the following display appears:

- Press button.
- Select function "10 - Adaptation" and adaptation channel 03 again.
- Carry out corrections to consumption indicator and confirm with Q button.

[ April 21, 2002, 15:07: Message edited by: SVTWEB ]
SVTWEB is offline   Reply With Quote
 
Page generated in 0.07415 seconds with 8 queries
[Output: 17.33 Kb. compressed to 15.90 Kb. by saving 1.43 Kb. (8.25%)]