View Single Post
Old October 28th, 2015, 04:32   #35
Mark Neil
Newbie
 
Join Date: Sep 2015
Location: Massachusetts
Default

Hi, the one I bought (part number posted somewhere in the forum!) fit perfectly in the tank, and secured (with the small turn) to the lugs in the bottom of the AdBlue tank. Maybe you got a different one if yours didn't do the same but had to "float free"?

I tried the short lead wrapped around the cap the other direction, but it wouldn't fit (would be stretched WAAY too tight if I tried to hard), so it was easier just to cut off the relevant length from the old heater lead and splice it on.

Several thousand miles now since replace and absolutely no issue. No more CEL or codes (knock on wood).
Mark Neil is offline   Reply With Quote
 
Page generated in 0.06389 seconds with 8 queries
[Output: 14.43 Kb. compressed to 13.00 Kb. by saving 1.43 Kb. (9.92%)]