Best adapter dimensions source

Has anyone had luck with available dimensions for making an adapter plate?there are a lot of photos available when searching. Toyota or ax to bhw


Sent from my iPhone using Tapatalk

Gas to diesel out of Canada, also a member here, is the "best" by most accounts. Cost less than most people adapting a cummins to a chevy/ford.


Acme has supposedly fixed the misalignment issues they had on their adapters.

There are others but are lesser known/posted.

Yah I’m wondering about the credibility of the milling dimensions posted online


Sent from my iPhone using Tapatalk

The tdi cad drawing over on the Sullivan vanagaon site are accurate from what I can tell. I had a slight issue with the dowel location on mine but that was more due to my process than the drawing .

Is there a thread that accounts for all the adapter options that are out there and who makes what?

It seems that there are several makers at several price points that do adapters, but no one thread or post that accounts for all of the options and simplifies the selection process.

This becomes an issue with multiple bellhousing options, say on AX15 where you could use a less expensive adapter setup if you just swap to a different bell.

Steve