View Single Post
Old April 21st, 2004, 12:24   #4
tsterkel
Veteran Member
 
Join Date: Dec 2002
Default frequently asked torque specs

AND RIVNUTS!, thanks!
[ QUOTE ]
Torque specifications (Ft-lbs)
ALH engine:
(always replace bolts in bold)
Drian plug: 22
Cam bearing cap: 15
Vacuum pump: 15
Valve cover: 7
Cam sprocket: 33
T-belt tensioner: 15
IP sprocket bolts: 18
Engine to Body mount: 30 + 1/4 turn
Engine mount to body mount: 44 + 1/4 turn
Crank shaft bolt: 80 + 90 degrees
*Oil pan bolts:
*Front seal carrier bolts:
*Rear seal carrier bolts:
*Flywheel to crank bolts:
*Pressure plate to flywheel bolts:
Bell housing to engine block:
Starter bolts:
*Oil filter housing bolts:
Serpentine belt tensioner: 18
Thermostat housing:
*Connecting rod bolts:
Large timing belt roller: 30 + 1/4 turn
Small upper timing belt roller bolt:
Small lower timing belt roller nut:
Intake Manifold to head bolts:
*Cylinder head bolts:
Injection pump to bracket bolts:
Water pump bolts: 11 (?)
Engine mount to engine bolts:




So, obviously you can tell that I have been frequently asking myself what some of these are.
I don't have a bently (well I do but...long story)
and I work on my car alot. I'd rather not over torque a bunch of stuff on my car.
If any of you guys know these, I would sure appreciate you letting us all know what they are. I'll come back and edit this post as they come along.
I did a bunch of searching, but trying to find specific stuff like this is a bear if you don't already know where to look.
I'll put a star by the ones I really need.
Thanks!
(and could we stickey this till it gets filled in?)
If anyone has any suggested additions to the list, I'll stick 'em on here.
-rob

[/ QUOTE ]
tsterkel is offline   Reply With Quote
 
Page generated in 0.06804 seconds with 8 queries
[Output: 15.29 Kb. compressed to 13.87 Kb. by saving 1.42 Kb. (9.28%)]