So about 2 weeks ago my check engine light came on in my 09 jetta tdi. I pulled the code which turned out to be a p13d0. After researching the code on here, I bought a set of glow plugs off of eBay ( 03L905061F ). I probably should have swapped the glow plugs around first to ensure that it was the plug and not the harness but I didn't.
After replacing the plugs this past Saturday I thought I was good to go. Cleared the codes and they didn't come back that is until Monday morning. Now, all the cylinders have fault codes. Here's the kicker, while pulling off the glow plug wiring connectors all the bottoms of the connectors remained stuck on the glow plugs. I had to pull them off separately. I'll post a picture showing the connector without the bottom in a little bit.
I pieced them back together as best as I could but was missing three out of the four washers.
So the question is now, did I jack up the harness so that it's causing the new faults or does the problem lie with my eBay plugs? Thanks for the help guys.
After replacing the plugs this past Saturday I thought I was good to go. Cleared the codes and they didn't come back that is until Monday morning. Now, all the cylinders have fault codes. Here's the kicker, while pulling off the glow plug wiring connectors all the bottoms of the connectors remained stuck on the glow plugs. I had to pull them off separately. I'll post a picture showing the connector without the bottom in a little bit.
I pieced them back together as best as I could but was missing three out of the four washers.
So the question is now, did I jack up the harness so that it's causing the new faults or does the problem lie with my eBay plugs? Thanks for the help guys.