jetta 97
Vendor
First I would like to tank you to unpimpZauto for finding out that immo 3 cluster can be rewire on circuit board and it can be use in 99.5 cars:
http://forums.tdiclub.com/showpost.php?p=3185904&postcount=70
I have done first MFA Immo 3 Sprot cluster in 99.5 car.None CAN car with CAN cluster.
I had to add wiring and stalk which can be found here how to do it:
http://forums.tdiclub.com/showthread.php?p=459818
After that you need to go in address 19 and recode it to 00002.
The tricky part was immobilizer light.I had to install coil reader which on 99.5 will be on key tumbler but pins are missing .
Then I had run wires from coir reader to cluster.Then it comes other problem. As you have none immo ECU key want be able to adopt the normal way , so knowing eeprom and addresses in it I had to add manually key.
This part is not easy to explain so I will just say this much about it.
Here is the video I made :
http://www.youtube.com/watch?v=jgD8jjqJpW8
http://forums.tdiclub.com/showpost.php?p=3185904&postcount=70
I have done first MFA Immo 3 Sprot cluster in 99.5 car.None CAN car with CAN cluster.
I had to add wiring and stalk which can be found here how to do it:
http://forums.tdiclub.com/showthread.php?p=459818
After that you need to go in address 19 and recode it to 00002.
The tricky part was immobilizer light.I had to install coil reader which on 99.5 will be on key tumbler but pins are missing .
Then I had run wires from coir reader to cluster.Then it comes other problem. As you have none immo ECU key want be able to adopt the normal way , so knowing eeprom and addresses in it I had to add manually key.
This part is not easy to explain so I will just say this much about it.
Here is the video I made :
http://www.youtube.com/watch?v=jgD8jjqJpW8
Last edited: