View Single Post
Old March 1st, 2018, 13:34   #1
SeanDieselB
Newbie
 
Join Date: Sep 2012
Location: MD
TDI(s): 82 pick-up
Fuel Economy: 43
Default Does anyone have a flywheel sitting in the open?

So I need help, I machined down my flywheel before I replace the clutch and it turned out well... I think.

The issue is that I didn't realize you need to machine the top where the pressure plate bolts down as well?
I didn't check what the difference in height was between the two before I started so now I don't know how much material I removed from the face of the flywheel. Does anyone have access to a good flywheel that can measure the height of the step?
in 1,000s of an inch please!
SeanDieselB is offline   Reply With Quote
 
Page generated in 0.08854 seconds with 8 queries
[Output: 15.32 Kb. compressed to 13.88 Kb. by saving 1.44 Kb. (9.40%)]