Ok so I got my block heater installed. 2015 Golf TDI SE. I read I should install one of these quick connects. Involves cutting the end of the cord. I found this instead. Then I realized I could split it and also run a battery tender. Problem is where to mount the plug. I was just going to put it on the right side of the bumper. It was suggested to get a spring loaded flip up license plate holder. Now that's slick.
Here's the part I need help with. Can I use a hole saw to cut a 49mm hole approx 2" in my bumper directly behind my license plate? I don't have parking sensors yet. Is there anything I should watch out for? I've looked at pictures, it looks like dead space.
*Please don't post just to complain about my picture size. Only reply if you think you have helpful info.
Here's the part I need help with. Can I use a hole saw to cut a 49mm hole approx 2" in my bumper directly behind my license plate? I don't have parking sensors yet. Is there anything I should watch out for? I've looked at pictures, it looks like dead space.
*Please don't post just to complain about my picture size. Only reply if you think you have helpful info.
Last edited: