View Single Post
Old May 24th, 2020, 08:07   #2
tactdi
Veteran Member
 
tactdi's Avatar
 
Join Date: Jun 2010
Location: North Carolina
TDI(s): 2005.5 Jetta
Default

Check the pick a part yards in your area for Jetta's.

You can pull the clutch master without too much trouble and then pull the
sensor off the master, and cut the wire connector going to the harness.

You will need one of those pin extractor tools (FLAPS usually have them), to
replace the wire connector (if that is what needs replacing).
tactdi is offline   Reply With Quote
 
Page generated in 0.06468 seconds with 8 queries
[Output: 14.44 Kb. compressed to 12.94 Kb. by saving 1.50 Kb. (10.36%)]