View Single Post
Old May 15th, 2018, 16:17   #4
rallywagon
Member
 
Join Date: Sep 2007
Location: Western NC
Default Bleeding Then...

Does your slave piston still have the nylon ball on the end? If so...

Sounds like you have all the pieces. Mount the slave, fill up the brake fluid reservoir and bleed...
- close bleed screw
- have helper press clutch to floor and HOLD IT THERE while you open then close the bleed screw
- helper pumps the clutch a few times HOLDS it to floor while you open then close the bleed.

Clutch pedal must be on the floor every time you open the slave bleeder. Lift the clutch pedal ONLY when the bleed screw is closed.

Will take 5 to 10 times.
rallywagon is offline   Reply With Quote
 
Page generated in 0.06446 seconds with 8 queries
[Output: 14.36 Kb. compressed to 12.93 Kb. by saving 1.43 Kb. (9.95%)]