View Single Post
Old October 21st, 2010, 11:15   #4
ryanp's Avatar

BRM Turbo Upgrade

This will be a bolt on upgrade for you guys with the BRM engines, I've fitted a few of these to Caddies with the BLS engine (our BRM basically) and they work a treat, one customer claimed 190WHP but i've not seen the dyno printout

We can do a good deal along with some PD150 injectors


12mm pump-

Its based on an 11mm body with a Genuine Bosch 12mm head and lots of internal upgrades. Has plenty or fuel for any size injectors, i had these running with .341's (below) and it ran sweet at part throttle and toasted the tyres at full throttle with minimal smoke (until i turned them up!! haha)

The pump has done around 1000 or so miles since being built
Ideally requires a new plug as i broke the connector when i was messing around. I'd like 1000 inc shipping, getting these built properly is not easy, willing to listen to sensible offers on all parts!!!

.341 injectors-

These have at most 200miles on them, i ran R520's before (below!!) I maxed the R520's out and these were installed for 1 dyno run and a bit of tuning before the engine was parted out. They were fitted to brand new bodies, I'm asking 550. No need for core returns but 50 will be credited if you do!
I made 280hp easily and one customer has 314hp with an 11mm pump!!!!!

R520's on Bodies

These are only 800miles old and ran perfect, only changed due to upgrade to .341's above. The R520's and 12mm pump are good for around 280hp according to my last dyno.
I'd like 350 for these

I'll have more stuff to list shortly, T4 pistons and custom H beam 1z/AHU rods

02M 6 Speed Conversions + Euro Parts - 6 Speed Setups for A4 + A5 platform,PD150 Intakes, TIP kits, Turbo's, Injectors as well as anything else!! PM Me! - Click HERE

Last edited by ryanp; January 2nd, 2013 at 09:38.
ryanp is offline  
Page generated in 0.07389 seconds with 8 queries
[Output: 18.72 Kb. compressed to 16.97 Kb. by saving 1.75 Kb. (9.34%)]