xdrift0rx
Active member
Okay so I needed to get off the fuel stop solenoid since it was giving me an error in the vag com. I went out and got a 24mm wrench. Well it ended up rounding off...so we continued to remove pieces to get better access to it and try and get some big pliers in there...So I eventually said why don't we just take off this cast iron looking piece? So we keep pulling apart and then we slide the cast iron out slowly....sweet! now we have plenty of room...I keep pulling...and the injection pump puked out its guts. I knew right then and there I was F%(*ED.
So...I got the solenoid off...and saw inside the pump there were rolly things...springs...etc....I know I need to pop the pump off (so now I need to re-time the engine). Can I safely re-assemble this thing? Are there any step-by step guides? I did come across This link here but I could tell it wasnt the same top as ours. What is my best bet? I would much rather rebuild this thing myself if possible...the money is much needed for other things...
Please help!
So...I got the solenoid off...and saw inside the pump there were rolly things...springs...etc....I know I need to pop the pump off (so now I need to re-time the engine). Can I safely re-assemble this thing? Are there any step-by step guides? I did come across This link here but I could tell it wasnt the same top as ours. What is my best bet? I would much rather rebuild this thing myself if possible...the money is much needed for other things...
Please help!