Festa
Veteran Member
The squish area that I should have is .61-.63mm but with a decked block and ceramic coated pistons it appears I will only have a squish area of .34mm, this possibly isn't enough. Now I understand the possibility of rod stretch at 5500rpm and expansion in the engine, but would 4340 h beam rods stretch as much as an oe rod ?
I may have to get a head gasket made up to allow for extra clearance but thought I would ask on here first as the worst that could happen is piston to head contact.
Think I should have removed material off the piston top...
Thanks in advance
I may have to get a head gasket made up to allow for extra clearance but thought I would ask on here first as the worst that could happen is piston to head contact.
Think I should have removed material off the piston top...
Thanks in advance