View Single Post
Old August 18th, 2014, 08:39   #13
nate0031
Veteran Member - TDIClub Contributor
 
nate0031's Avatar
 
Join Date: May 2012
Location: SE Ohio
TDI(s): 96 B4 Passat
Default

I was swapping on the new oil pan yesterday, and just about had a heart attack. The AWM pan wasn't the same. The bolt pattern is the same, but the CJAA pan has sections that extend out beyond the bolt holes to clear the windage tray. Here's a Picture:



After removing the windage tray, I see that the block continues underneath, so there is a straight path and no issue with having a surface to seal against. So one question, what to do about the windage tray? I'm guessing simply cutting the tabs off would not be best. Is there another that will fit with this pan? One out of an ALH maybe?
__________________
2005.5 VW Jetta - 1.9 Turbo Diesel - 5 Speed
2000 Audi A6 - CJAA Common Rail TDI - Quattro - 01E
2005 Ford F-350 - 6.0L Turbo Diesel - Auto - 4x4

Last edited by nate0031; August 18th, 2014 at 08:43.
nate0031 is offline   Reply With Quote
 
Page generated in 0.06964 seconds with 8 queries
[Output: 15.57 Kb. compressed to 13.81 Kb. by saving 1.76 Kb. (11.30%)]