View Single Post
Old April 16th, 2018, 19:23   #25
Veteran Member
Seatman's Avatar
Join Date: Apr 2010
Location: Scotland
Fuel Economy: No idea

Originally Posted by OlyTDI View Post
Can you elaborate on the "cup" needed for the Cupra R bushings? Does the bushing need to seat past the end of the receiving piece? If so, what does this cup seat against when squeezing the bushing in?


The proper tool is cupped, the end of the bush sticks out past the hole anyway but sometimes a poly bush can require that little extra push to get it fully home.

I've just replaced mine with poly though and the proper tool worked perfect.
Seatman is offline   Reply With Quote
Page generated in 0.04386 seconds with 8 queries
[Output: 15.22 Kb. compressed to 13.69 Kb. by saving 1.53 Kb. (10.07%)]