jbourke367
Well-known member
So my car is due for inspection in September. In its current state it will not pass due to the airbag light on the dash. The light is for the crash sensor on the drivers side.
2 Faults Found:
01221 - Crash Sensor Side Airbag; Driver Side (G179)
29-10 - Short to Ground - Intermittent
00532 - Supply Voltage B+
07-10 - Signal too Low - Intermittent
I was going to start with unplugging the battery and waiting 10-20 minutes, unplugging the sensor and inspecting the wires, cleaning the connections then plugging back in to try and clear the code. My question is how to get the carpet up. After some research it seems that this sensor is not under the seat but underneath the carpet. How exactly do I pull the carpet up? I am not sure what trim I have to remove to do so.
2 Faults Found:
01221 - Crash Sensor Side Airbag; Driver Side (G179)
29-10 - Short to Ground - Intermittent
00532 - Supply Voltage B+
07-10 - Signal too Low - Intermittent
I was going to start with unplugging the battery and waiting 10-20 minutes, unplugging the sensor and inspecting the wires, cleaning the connections then plugging back in to try and clear the code. My question is how to get the carpet up. After some research it seems that this sensor is not under the seat but underneath the carpet. How exactly do I pull the carpet up? I am not sure what trim I have to remove to do so.
Last edited: