View Single Post
Old December 16th, 2014, 06:04   #42
dustingebhardt's Avatar
Join Date: Oct 2010
Location: Tulsa, OK

I editted my post to make is clearer that my install process appears to be nontypical. I do want to say thanks for making this part, and it appears to be working well. In regards to the hammer use, I used a small hammer and very light force when adjusting the part. One edge of your machined part was biting into the cast motor body and beginning to gall. I could have probably backed out the screw, repositioned the part, and tightly hold it in position while tightening the screw.

Thanks again,
2010 Jetta Sportwagen TDI: Fiesta Red, 6MT, ContiExtreme DW 225/50/16
dustingebhardt is offline   Reply With Quote
Page generated in 0.06544 seconds with 8 queries
[Output: 15.05 Kb. compressed to 13.48 Kb. by saving 1.58 Kb. (10.46%)]