I have a G40 Vagcom code, P3007-000, which shows No Signal to the Camshaft Position Sensor. For the life of me I cannot locate where that sensor is---there is nothing at the camshaft wheel. Can anyone show me where this sensor is located on this BEW engine? Car starts and runs well, poor mileage. However, even though it starts, it takes many revolutions before it fires, but it fires and runs every time.
This code is combined with 2 V157 codes, 19557 and 19559, Motor for Intake Manifold Flap Open or Shorted and Motor for Intake Manifold Malfunction.
My assumption is that it is worthless to try and tshoot that problem without first fixing the CPM problem. Any other ideas?
This code is combined with 2 V157 codes, 19557 and 19559, Motor for Intake Manifold Flap Open or Shorted and Motor for Intake Manifold Malfunction.
My assumption is that it is worthless to try and tshoot that problem without first fixing the CPM problem. Any other ideas?