View Single Post
Old September 15th, 2017, 17:31   #7
Veteran Member
Join Date: Jul 2004
Location: Bend, Oregon

Originally Posted by yvon g View Post
any one with pin positions in the ecm for an 03 jetta tdi?
In my opinion, digging into pinouts for the ECU is a waste of time. You have broken wires somewhere. Start by doing a good inspection of the wire harness. I went through something similar on a Duramax. It would die going over bumps. Looked over the engine compartment and saw a wire harness sitting on an aluminum boost pipe and it had black around it. Inspected it and found two CAN wires worn through and they would move just right and short together through the pipe.

What I'm saying is looking and understanding what you see is key to a good visual inspection.
Can rent movies at BlockBuster.
whitedog is offline   Reply With Quote
Page generated in 0.07113 seconds with 8 queries
[Output: 15.13 Kb. compressed to 13.58 Kb. by saving 1.55 Kb. (10.25%)]