View Single Post
Old February 7th, 2019, 21:38   #39
Digital Corpus
Veteran Member
 
Digital Corpus's Avatar
 
Join Date: Mar 2008
Location: Ontario, California
Default

I’m bumping this for confirming information. The Harbo Freight tool (#63705) is a good bet. The stock tie rods use the 1-1/4” die and the new AC Delco replacement tie rods used the 33.6 mm die. The latter are about 1/2” longer, but the tie rod end (not the end of the inner tie rod, but the ball joint end that bolts to the knuckle) has more than enough depth to deal with the excess. The threading is M14x1.5 for the record.
__________________
Turbo Upgrade | Engine Rebuild | Photos | Lighting Mods
Dyno Graphs | 4-Bar sensor | GTB1756VK | Hot-swappable 2.5" down pipe | R520's | PD130 intake manifold
Digital Corpus is offline   Reply With Quote
 
Page generated in 0.06496 seconds with 8 queries
[Output: 15.50 Kb. compressed to 13.92 Kb. by saving 1.58 Kb. (10.16%)]