I'm very interested in make this mod and i believe that a lot of members of this forum too...who know!
I don't understand at all the information of other threads...
Material needed:
-3.3V Zener diode
-1K Potenciometer
MAP sensor wires:
Pin1: signal ground
Pin2: temperature output voltage
Pin3: 5V supply and reference voltage
Pin4: Pressure output voltage
in wich MAP sensor pin i must to install Zener diode?
Potenciometer must be connected to ground.... to MAP sensor ground(Pin1) or chassis ground?
Wich is the correct Ohm resistance? 100Ohm?
I suppose that boost is adjusted with potenciometer... A bigger value that 100Ohm is more or less boost? Thanks in advance..
I don't understand at all the information of other threads...
Material needed:
-3.3V Zener diode
-1K Potenciometer
MAP sensor wires:
Pin1: signal ground
Pin2: temperature output voltage
Pin3: 5V supply and reference voltage
Pin4: Pressure output voltage
in wich MAP sensor pin i must to install Zener diode?
Potenciometer must be connected to ground.... to MAP sensor ground(Pin1) or chassis ground?
Wich is the correct Ohm resistance? 100Ohm?
I suppose that boost is adjusted with potenciometer... A bigger value that 100Ohm is more or less boost? Thanks in advance..
Last edited: