Check engine light on - Throttle Body Actuator

Check engine light came on today on my 2009 Jetta TDI. Did a scann and this is what I got. Any idea what I'm looking at here?

Sunday,19,November,2017,17:59:41:50329
VCDS Version: Release 17.8.0 (x64) Running on Windows 10 x64
www.Ross-Tech.com

Address 01: Engine Labels: 03L-906-022-CBE.clb
Control Module Part Number: 03L 997 016 N HW: 03L 906 022 J
Component and/or Version: R4 2,0L EDC G000SG 8680
Software Coding: 0050072
Work Shop Code: WSC 00066 000 00000
VCID: 3D7B138464B537AEA1-8068
2 Faults Found:

001592 - Throttle Body Actuator Bank 1 (J338)
P0638 - 000 - Implausible Signal - Intermittent - MIL ON
Freeze Frame:
Fault Status: 10100000
Fault Priority: 2
Fault Frequency: 66
Reset counter: 255
Mileage: 214595 km
Time Indication: 0
Date: 2000.00.00
Time: 05:34:59

Freeze Frame:
RPM: 2438 /min
Speed: 39.0 km/h
Voltage: 14.29 V
Lambda: 99.4 %
Bin. Bits: 00000000

008449 - Throttle Valve Actuator Control System
P2101 - 000 - Malfunction - MIL ON
Freeze Frame:
Fault Status: 11100000
Fault Priority: 2
Fault Frequency: 1
Reset counter: 255
Mileage: 214608 km
Time Indication: 0

Freeze Frame:
RPM: 0 /min
Speed: 0.0 km/h
Voltage: 12.16 V
Lambda: 99.4 %
Bin. Bits: 00000000


Readiness: 1 1 0 0 0

If you look between the radiator and engine, the valve with the intake hose on it coming up from the inter-cooler. that valve is sticking. I removed mine, cleaned it up to where it would move free, and re-installed. was fine for a while then stickied up again in a few months. had to do it again with a hi-temp lube on the valve bushings. didn't think this was a high temp area being on the intake but the EGR valve is mounted next in line. mine has been good for a while now.

If it sticks and wont let the car run, leave your key on and hit it a few times with a wrench to jar it loose so you can get home. when you turn your key off it tries to close. That's what I had to do. the 3 mount bolts for it are star tips. not Phillips or triple square.

good luck, not a hard job. took me about 1.5 hour the first time. I removed the hose coming up from the intercooler out of car first to make it easy to get to the mount bolts on valve, that tube was kinda hard to get back into place after valve bolted back in.

check this thread http://forums.tdiclub.com/showthread.php?t=475327

there are a few others out there too.

Great! Thank you for the info