View Single Post
Old May 1st, 2009, 08:29   #55
DanG144
Veteran Member
 
Join Date: Aug 2007
Location: Chapin, South Carolina, USA
Default

Look at the photos and captions near the end of the fan troubleshooting guide in post #1 of this thread. It covers the fan resistances.

Here is a copy of a photo caption:
"This is a shot of the drivers side fan connector. Note the spade connections. In this shot pin 1 is bottom, pin 2 middle, pin 3 top. These are 1/4" spades. The resistance on my good fan was 1-3 0.6 ohms, 1-2 0.8 ohms, 2-3 1.2 ohms."

You will have to be more specific on what you are asking for about the resistances on the internals. (And I would have to go and measure one.) The important internal resistances should be the same as those measured from the plug. You are essentially measuring:
pins 1-2 across the resistor.
pins 1-3 across the fan winding.
pins 2-3 across both the fan winding and resistor in series. (I know they do not quite add up, but that is life; not perfect but good enough.)


The resistances across the brushes should be on the order of 0.1 or 0.2 ohms.

Does that help?


DanG144 is offline   Reply With Quote
 
Page generated in 0.06521 seconds with 8 queries
[Output: 14.87 Kb. compressed to 13.44 Kb. by saving 1.43 Kb. (9.62%)]