View Single Post
Old September 5th, 2011, 16:07   #27
Join Date: Jun 2008
Location: BARI,ITALY

Originally Posted by corrado tdi View Post
Have you considered machining mk4 rotors to fit the hole pattern on 5x112 hubs?
I have machined a new rotors with 5x112 holes pattern,I need only the last information for complete my swap,the dimension of spline,i know only that is 36 teeth
carrarmat is offline   Reply With Quote
Page generated in 0.07641 seconds with 7 queries
[Output: 14.55 Kb. compressed to 13.08 Kb. by saving 1.47 Kb. (10.11%)]